Table of Contents
Advertisement
6.3.3 Smart Mode
The system will keep detecting the wired network bandwidth usage. When the wired network is
disconnected, or the bandwith usage is over the pre-defined threshold, the system will wake 3G/3.5G USB
dongles up for backuping wired network or sharing traffic.
When clicking Smart Mode, you can see there is an Idle time setting.
If you set the idle time, the system will provide power for USB port based on the time you set befor
3G/3.5G USB dongles enter power saving state. Adding the USB port idle time helps you have time for
dialing 3G/3.5G USB dongles.
*Take the figure above as example. If the idle time is 10 minutes, the system will provide power for USB
prots for 10 minutes. During these 10 minutes, if there is an trigger condition occurred, 3G/3.5G USB
dongles will start to connect, providing the immediate network backup or sharing.
If no trigger condtion occurs, there will be no power for 3G/3.5G USB dongles to save electricity.
A. Trigger Condition:
Trigger condition 1: all the chosen wired networks are detected failed
Trigger condtion 2: the bandwidth of the chosen wired network is over the pre-defined threshold
Either the condtion above is triggered, 3G/3.5G USB dongles will be the backup for network, or share
the bandwidth.
59
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
