Table of Contents
Advertisement
Interface:
Retry:
Retry Timeout:
When Fail:
(1) Generate the Error Condition in the System Log: If an ISP
(2) Keep System Log and Remove the Connection: If an ISP
Select the WAN Port that enables Network Service Detection.
This selects the retry times for network service detection. The default is
five times. If there is no feedback from the Internet in the configured
"Retry Times", it will be judged as "External Connection Disconnected".
Delay time for external connection detection latency. The default is 30
seconds. After the retry timeout, external service detection will restart.
connection failure is detected, an error message will be recorded in
the System Log. This line will not be removed; therefore, the some of
the users on this line will not have normal connections.
This option is suitable under the condition that one of the WAN
connections has failed; the traffic going through this WAN to the
destination IP cannot shift to another WAN to reach the destination.
For example, if users want the traffic to 10.0.0.1 ~ 10.254.254.254 to
go only through WAN1, while WAN2 is not to support these
destinations, users should select this option. When the WAN1
connection is disconnected, packets for 10.0.0.1~10.254.254.254
cannot be transmitted through WAN 2, and there is no need to remove
the connection when WAN 1 is disconnected.
43
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
