Table of Contents
Advertisement
10.1.1.2. Client to Gateway Setting
The following describes how an administrator builds a VPN tunnel between devices. Users can set
this VPN tunnel to be used by one client at the client end. If it is used by a group of clients, the individual
setting for remote clients can be reduced. Only one tunnel will be set and used by a group of clients,
which allows easy setting.
Situation in Tunnel：
Tunnel No.：
Tunnel Name：
Interface：
Enabled：
Set the embedded VPN feature, please select the Tunnel number.
Displays the current VPN tunnel connection name, such as XXX Office.
Users are well-advised to give them different names to avoid confusion.
Note: If this tunnel is to be connected to the other VPN device, some
device requires that the tunnel name is identical to the name of the host
end to facilitate verification. This tunnel can thus be successfully enabled.
Users may select which port to be the node for this VPN channel. They
can be applied for VPN connections.
Click to Enable to activate the VPN tunnel. This option is set to Enable
by default. After users set up, users may select to activate this tunnel
feature.
147
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
