Table of Contents
Advertisement
Configuring "Assigned Routing Mode" for load Balance：
IP Group: This function allows users to assign packets from specific Intranet IP addresses or to
specific destination Service Ports and to specific destination IP addresses through an assigned WAN to
the Internet. After being assigned, the specific WAN will only support those assigned Intranet IP
addresses, destination Service Ports, or destination IP addresses. Those which are not configured will
go through other WANs for external connection. Only when this mode is collocated with "Assigned
Routing" can it bring the function into full play.
Example 1：How do I set up the Assigned Routing Mode to keep all Intranet IP addresses from going
through WAN2 when the destination is Port 80, and keep all other services from going through WAN1?
As in the figure below, select "HTTP[TCP/80~80]" from the pull-down option list "Service", and
then in the boxes of "Source IP" input "192.168.1.0 ~ 0" (which means to include all Intranet IP
addresses). Retain the original numbers "0.0.0.0" in the boxes of "Destination IP" (Which means to
include all Internet IP addresses). Select WAN2 from the pull-down option list "Interface", and then click
"Enable". Finally, click "Add New" and the rule will be added to the mode. After the rule is set up, only
packets that go to Port 80 will be transmitted through WAN2, while other traffics will be transmitted
through WAN1.
53
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
