Eneo BCR-3004 Operating Instructions Manual page 72

3) Access Menu - Network - LAN - Ethernet in DVR.
4) Set IP TYPE to STATIC.
5) IP address popup button
In case of router connection
Assign an internal IP address to the DVR. (Ex: 9.68.0.05, The IP scheme must match your router's
settings)
The Assigned IP address should only be used for the DVR internally (On the same LAN).
In case of direct connection
Assign the static IP address to DVR. (Ex: .06..95, This address is provided by your service provider)
Static IP address assigned by ISP is the IP address for DVR. (On the same LAN or WAN)
6) Set IP port. (50000 recommended and is default on DVR)
7) Input GATEWAY assigned from the ISP.
8) Input SUBNET MASK assigned from the ISP.
9) Save settings and exit menu.
0) Turn off the Modem or Router provided by the ISP, and turn it on again.
(This process is to reset client's MAC from the ISP. Wait for 30 seconds after turning on. )
) Access DVR with IRS program.
7