Eneo BCR-3004 Operating Instructions Manual page 45

6.4.2 Motion List Option Item
The „MOTION" list option item is selectable from „EVENT" group icon.
By selecting „MOTION" list option item, window with „SETUP" tab and „ACTION" tab appears.
1) SETUP Tab Window
Set Motion Detection setting for each channel
Motion Mask Zone Setup Window
• NO. : Click the „NO. (Number)" button to show
• TYPE: Set motion mask setting „ON" or „OFF" for
each channel.
• BEEP: Set beeping sound „ON" or „OFF" in case
motion event occurs.
• SENSITIVITY: Set sensitivity among VERY HIGH,
HIGH, STANDARD, LOW and VERY LOW.
• MASK ZONE: Click to go to Motion Mask Zone
setup window. (refer to illustration on next page)
• ZONE VIEW: Motion detected cells will be
displayed in red while in live view.
• DETECT CELL NUMBER: Set number of cells for
Mask Zone from  to 80 cells.
Motion detection will only start if more cells are
detected than number of cells defined at DETECT
CELL NUMBER selection.
• PREVIOUS: Go to previous channel page.
(not available in 4 channel DVR)
• NEXT: Go to next channel page.
(not available in 4 channel DVR)
Deactivates • Cell Setup
Motion Detection
Click left button of mouse to set Motion Mask Zone
for selecting or clearing blocks.
Activates
• Block Setup
Motion Detection
Click selected cell and drag it to desired position.
All cells within the block will be selected.
Select: Activates motion detection
Clear: Deactivates motion detection
Reverse: Activate inactive blocks or deactivate
active blocks
• Click OK on the popup menu to save setting and
exit.
45
the „COPY SETTINGS" popup menu.
(There are alarm channels 1~4 shown by
default).