Eneo BCR-3004 Operating Instructions Manual page 51

2) EMAIL Tab Window
NOTE: Some ISP does not support POP or SMTP email support. If you are using such e-mail accounts it may
not be possible to use E-Mail notification option listed on this page.
Ask your ISP or E-Mail provider for detailed SMTP configuration procedure.
3) EVENT Tab Window
DVR can be set to send events to CMS (Central Management Software) program.
• SEND E-MAIL ON/OFF: Select ON to enable,
OFF to disable
• SEND SEVER IP: Enter the SMTP (out going mail)
server IP.
• SEND PORT: Enter the SMTP (out going mail)
server port number obtained from your ISP.
(in many cases your Internet Service Provider may
have special setting requirements or restriction
for SMTP settings. You may have to obtain an
email account service that provides SMTP relay
service that lets you bypass the ISP restrictions.)
Set send server port number from 0 to 65000.
• AUTHENTICATION: enable the check box if your
ISP or email account provider requires server
authentication for outgoing mail services.
• SEND SEVER ID: Enter the e-mail user ID or ID to
authenticate with SMTP (provided by ISP or e-mail
accounts provider) using the virtual keyboard.
• SEND SEVER PW: Enter the e-mail PW or PW to
authenticate with SMTP (provided by ISP or e-mail
accounts provider) using the virtual keyboard.
• SENDER: Enter the sender's e-mail address.
• RECIPIENT: Enter the recipient's e-mail address.
• ACTIVE: Select checkbox to activate event.
• IP ADDRESS: Shows IP address of the PC, in
which event server program runs.
• PORT: Shows Port of the PC, in which event server
program runs.
Port setup is from 0 to 65000.
5