4.2 Hardware Installation
4.2.1 Rack Mounting
. Remove the cross head screws (four on each side) located near the front panel on the right and left side of the unit.
. Secure the rack mount brackets to each side using same cross head screws that were just removed.
3. Install the unit into the 9 inch wide rack (follow the rack manufacturer's instructions.)
4.2.2 HDD (Hard Disk Drive) connection
CAUTION !
Electrostatic discharges
Any electrostatic energy coming in contact with the hard disk or other sensitive internal parts
can damage them permanently. Improper handling could void the warranty of the hard disk.
When working with electrostatic sensitive devices such as a hard disk or the Divar unit, make
sure you use a static-free workstation.
DANGER !
Electrical voltage
Risk of electric shock
Before installation of the hard disk, unplug the power cord of the DVR and wait for at least
30 seconds.
. Connect Main Board and HDD using SATA cable and HDD power cable.
. For the single Hard Drive installation make sure you install the HDD onto HDD location.
3. For the two Hard Disk Drive installation make sure you install the first HDD onto HDD location and then install the
second HDD onto HDD location.
4. Install the HDD(s) to the HDD bracket by using the bolts (included in the package).
5. Attach the HDD bracket into the bottom case.
(Refer to the pictorial examples on following page.)