Eneo BCR-3004 Operating Instructions Manual page 55

2) HOLIDAY Tab Window
Set national holidays or holidays on calendar to record as setting for Sunday in Schedule Record Setup.
The „HOLIDAY" setting allows the option to preset all Holidays on the DVR calendar. You can then specify to record
with the „HOLIDAY" settings on the „SELECT DAY OF WEEK" in the „SCHEDULE RECORD" setup.
NOTE: Up to 100 days can be set as holiday.
Holidays that do not fall on the same date each year should be updated once the current year's
holiday has passed.
3) TIME SYNC Tab Window
• ADD: Click the „ADD" button and today's month
and day will be added on the screen.
Click month and day to change the date of the
holiday. („ADD" option must be selected first to
add and change the month and date. After
adjusting all setting „SAVE" button confirms the
changed selection. Without clicking on „ADD"
button „MONTH" and „DATE" parameters are not
selectable.)
• DELETE: to delete the holiday schedule you must
select the check box located on far right hand side
and then click the „DELETE" button.
• SELECT DAY OF WEEK: Set selected day of week
as holiday. (Default is Sunday)
• : Current Page/Total Pages
01/01
• LEFT ARROW BUTTON
• RIGHT ARROW BUTTON
• CHECKBOX: Check box of the date to delete.
Press Delete button to delete selected date.
• AUTOMATIC SYNC: Choose between On/Off.
• TIME SERVER: Input sync server IP address (SNTP)
NOTE:
SNTP times server IP addresses are available
through the Internet. Level two time servers
are recommended due to faster update time.
The even if the „INTERVAL" setting is set
lowest to 0.5 hour depending on time server
chosen, you may have to wait receive the res-
ponse back from the SNTP server. If updates
do not happen for 3~4 cycles (example if
„INTERVAL" is set for 0.5 hours and within
2 hours if the time does not update) then time
server might not be active or may not respond
55
: Previous page
: Next page