Enabling The Ipsi - Avaya S8700 Series Installing And Configuring

Enabling the IPSI

1. Type change system-parameters ipserver-interface and press Enter.
2. On a duplicated media server, the system displays the following screen. Verify that the
primary control and the secondary control subnetwork addresses are correct.
change system-parameters ipserver-interface
SERVER INFORMATION
Secondary Control Subnet Address: 198.152.255.
OPTIONS
IPSI Control of Port Networks: enabled
The control subnetwork addresses typically match the most significant three octets of the
IP addresses of the server for the media gateway. The most significant three octets are the
first three groups of digits in the IP address. Select the configure server command on
the Maintenance Web Interface to see the IP address of the server.
An asterisk (*) to the right of the Control Subnet Address field means that
Communication Manager does not have the subnetwork information and the subnetwork
address displayed is incorrect.
3. If the information in the Primary Control Subnet Address field, the Secondary Control
Subnet Address field, or both fields is incorrect, use the Maintenance Web Interface to
change the media server configuration to match the Server IP address in configure
server. Under Server Configuration and Upgrades, click Configure Server to change the
media server configuration. Then return to this procedure.
4. Set the Switch Identifier field to the switch ID letter. Acceptable switch ID letters are A
through J. A is the default setting.
5. Set the IPSI Control of Port Networks field to enabled.
6. Press Enter to save the changes.
Installing and Configuring the Avaya S8700-Series Media Server
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
IPSI Host Name Prefix: birch
Primary Control Subnet Address: 198.152.254.
Switch Identifier: A
Enabling the IPSI
Page 1 of
0 *
0 *
February 2007
1
43