Hatteland HM 20T07 MIL User Manual page 29

OSD Menu Functions
1
2
4
3
USER SETTING: (Press "+" to access the sub-menu)
2
4
OSD SETTING: (Press "+" to access the sub-menu)
1
2
4
3
ZOOM: (Press "+" to access the sub-menu)
2
4
DIRECT ACCESS 1 & 2: (Press "+" to access the sub-menu)
1 2
4
3
NOTE:
NOTE:
NOTE:
User Controls
IND100064-17
UTILITIES:
Selecting this function will enable the user to configure the OSD menu, define
hot keys, verify BIOS Firmware version and miscellaneous operations.
DPMS
DISPLAY INPUT
AUTO SOURCE SELECT
FILTER
GAMMA
SERIAL ADRESS
OSD HORZ POSITION:
OSD VERT POSITION:
OSD BACKGROUND
OSD ROTATE
OSD MODE
USER TIME OUT
ZOOM LEVEL:
HORIZONTAL PAN:
VERTICAL PAN:
Define the hot key function ("+" or "-" front/under hatch buttons) to one of these OSD functions:
Brightness / Contrast / Zoom / Video Source / PIP* / No Function / Test Pattern
* By pressing the assigned hot key, the sequence of the selected input video source are:
Analog RGB1 / Analog RGB2 / DVI / Composite Video / S-Video.
When assigning video source to hot key function, please set the "AUTO SOURCE SELECT" to HIGH (see above).
Direct Access 1 default factory setting is NO FUNCTION
Direct Access 2 default factory setting is NO FUNCTION
: Disable / Enable the DPMS function.
: Disable / Enable input source name upon power up.
: Off = Disable auto source select function. (Default setting)
Low = Auto source select enabled ONLY in power up.
High = Auto source select ALWAYS enabled.
: Auto/On/Off - Signal Noise Reduction for Analog RGB1 Signal.
(Only available/functioning on custom models where required)
: 1.0 / 1.6 / 2.2 - Adjusts gamma on TFT display.
: Set Serial Remote Channel from 0 to 15.
(Consult "Serial Communication (SCOM) Interface" chapter in this manual
or the online "Serial Control Interface - MMD / MMC" manual for
complete instructions.)
Position the OSD menu horizontally.
Position the OSD menu vertically.
: Choose between Translucent or Opaque.
: Choose between Normal / Rotate. Will position the menu
either horizontally or vertically.
; Only available in Advanced/Full menu!
"NORMAL" = ALWAYS shows the Simplified version of the
OSD menu. Logo will be shown in the top left corner.
"TOGGLE" = ALWAYS show the Advanced/Full version of the
OSD menu. Logo will NOT be shown in the top left corner.
(Please refer to the beginning of this chapter for information)
: Adjust the OSD menu time out period in a step of 5 seconds.
Zooms in the display area from center.
Pan the display area horizontally.
Pan the display area vertically.
29
INB100005-8 (Rev 5)