Assembly And Installation - Crestron Cameo C2NI-CB Series Operations & Installation Manual

Cameo Keypads
Network Device Tree – Sub-Menu
Enter New Net ID

Assembly and Installation

Assembly of the keypad consists of placing the button caps/spacers in
position based on how the unit is programmed, securing them together
with a plastic button support, putting the button cap/spacer assembly in
place on the rear housing and switch assembly, and attaching the bezel.
The button caps are tapered, and are often installed in a shingle-style
pattern (refer to the
Configuration
keypad is with the LEDs on the left. It can, however, be inverted with the
LEDs on the right, but the original relationship of the button numbers to
the LEDs remains, i.e., with the unit inverted, row one is on the bottom –
12 • Cameo Keypads: C2N/C2NI-CB Series
5. Enter a new Net ID and press Enter.
6. Repeat this procedure for each additional network device
requiring a Net ID change.
"Keypad Overall Dimensions – Flush Mount
" illustration on page on page 5). Usual orientation of the
Crestron C2N/C2NI-CB Series
Operations & Installation Guide - DOC. 6346C