Crestron Cameo C2NI-CB Series Operations & Installation Manual page 25

Crestron C2N/C2NI-CB Series
If the keypad needs to be removed from the wall, there are two slots on
one edge of the bezel (visible in the figure on page 22). Use a flat blade
screwdriver to pry the bezel away from the wall plate, being careful to
avoid damage to the bezel.
Mounting Using Screws Through the Bezel
Refer to the figure on the next page and do the following.
If the keypad needs to be removed from the wall, remove the screws
securing the keypad to the mounting surface/back box, and pull the
keypad free.
Operations & Installation Guide - DOC. 6346C
3. Insert the keypad into the hole and press the bezel against the
plastic wall plate until it snaps securely into position.
4. Turn the Cresnet system power On.
1. Drill pilot holes through the bezel from the rear at each of the
drill center points. Then, from the front of the bezel, drill the
final holes and countersink as required. (Refer to C in the figure
on page 22.)
2. Place the plastic wall plate over the keypad with the smooth
surface facing out, and snap the wall plate and bezel together.
3. Attach the keypad to the mounting surface or to the back box
using the appropriate screws.
4. Turn the Cresnet system power On.
Cameo Keypads
Cameo Keypads: C2N/C2NI-CB Series • 21