Crestron Cameo C2NI-CB Series Operations & Installation Manual page 15

Crestron C2N/C2NI-CB Series
The Crestron Toolbox provides several methods to easily set or change
device Net IDs for any device on the network. The following method
permits you to change the Net ID of any device in the network through
the "Network Device Tree" window.
NOTE: This method prevents you from setting duplicate IDs.
This method lets you manually set the Net ID for any device in the
network, can be used to set any known Net IDs that require changing,
and may also be used for non-TSID equipment. This method will not
permit you to choose an ID already in use by another device. A warning
message will appear if you attempt to use an ID that is already in use.
Duplicate Net ID Warning Message
This method does not change the Net ID as assigned in SIMPL windows.
Refer to page 27 for the SIMPL Windows ID change procedure.
NOTE: You may also use SystemBuilder to perform Network ID setup.
Network Device Tree
Operations & Installation Guide - DOC. 6346C
1. Connect all network devices to the control system.
2. Open Crestron Toolbox and establish communications (refer to
page 29).
3. Select the Network Device Tree
Network Device Tree View.
4. Right-click on the device Net ID, and when the sub-menu
appears, select Change Network ID from the sub-menu.
Cameo Keypads
icon, or select Tools |
Cameo Keypads: C2N/C2NI-CB Series • 11