Crestron Cameo C2NI-CB Series Operations & Installation Manual page 20

Cameo Keypads
Decorator Mounting Installation
The keypad for Decorator mounting installation is supplied partially
assembled along with several items as listed in the following table.
Supplied Parts/Assemblies – Decorator Mounting
QTY
1
1
1
2
2
1
1
1
2
Assemble the keypad as described in the following steps. Refer to the
accompanying illustrations.
16 • Cameo Keypads: C2N/C2NI-CB Series
ITEM
Rear housing and switch assembly
Bezel assembly
4-pin female mini network
connector
Screws, Black, Phillips pan head,
4-40 x 3/16"
Single row spacer
Double row spacer
Triple row spacer
Plastic button support
Screws, Steel, Phillips, pan head,
6-32 x 7/8"
1. Arrange the button caps
and/or spacers in
position according to the
program plan. Attach
the plastic button
support to the button
caps/spacers, and put the
assembled parts in place
on the rear housing and
switch assembly.
2. Carefully position the
bezel assembly, LED
edge first, down and
over the button
caps/spacers and rotate
slightly into position on the rear housing and switch assembly.
Crestron C2N/C2NI-CB Series
DESCRIPTION
Rear housing with switch circuitry attached
Bezel and metal plate assembly, with ground wire
Used to connect Cresnet network cable to the keypad
Used to attach the bezel assembly to the keypad rear
housing and switch assembly
Switch cover for single non-operational switch
Switch cover for two non-operational switches
Switch cover for three non-operational switches
Used to hold the button caps/spacers together in
position
Used to attach the assembled keypad to a back box
Operations & Installation Guide - DOC. 6346C