Crestron ZUMLINK-KP Quick Start Manual

ZUMLINK-KP-
Zūm® Wired Keypad with Link Communication, Rocker Button
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/8886
For additional information on the Crestron®
ZUMLINK-KP-R, visit
www.crestron.com/model/6511187
Regulatory Model: M201937001
IMPORTANT NOTE: To comply with ISED CANADA
and FCC RF exposure compliance requirements,
the antenna used for this transmitter must be
installed to provide a separation distance of at
least 20 cm from all persons and must not be co-
located or operating in conjunction with any other
antenna or transmitter.
REMARQUE IMPORTANTE: Pour être conforme aux
exigences de conformité d'ISED CANADA et de la
FCC en matière d'exposition aux radiofréquences,
l'antenne utilisée pour cet émetteur doit être
installée de manière à assurer une distance de
séparation d'au moins 20 cm de toutes les
personnes. toute autre antenne ou émetteur.
Federal Communications Commission (FCC)
Compliance Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment

and receiver.
Connect the equipment into an outlet on a

circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV

technician for help.
Please note that any modifications to the device
software or configuration, including but not limited
to the init file(s), can cause device performance to
vary beyond the scope of the currently referenced
FCC authorization. Accordingly, if any user
modifications are sought to be made to the device
software or configuration, the user may be
required to independently seek fresh FCC and other
regulatory authorizations as relevant prior to