™
Cameo
Keypads
Network Device Tree – Sub-Menu
Enter New Net ID
Assembly and Installation
Assembly of the keypad consists of placing the button caps/spacers in
position based on how the unit is programmed, securing them together
with a plastic button support, putting the button cap/spacer assembly in
place on the rear housing and switch assembly, and attaching the bezel.
The button caps are tapered, and are often installed in a shingle-style
pattern (refer to the
Usual orientation of the keypad is with the LEDs on the left. It can,
however, be inverted with the LEDs on the right, but the original
relationship of the button numbers to the LEDs remains, i.e., with the unit
inverted, row one is on the bottom – row six is on the top, and
programming of the switches would have to be done accordingly.
12 • Cameo™ Keypads: C2N/C2NI-CB Series
5. Enter a new Net ID and press Enter.
6. Repeat this procedure for each additional network device
requiring a Net ID change.
"Keypad Physical
Crestron C2N/C2NI-CB Series
Views" illustration on page 4).
Operations & Installation Guide - DOC. 6346A