Physical Description - Crestron Cameo C2NI-CB Series Operations & Installation Manual

Cameo Keypads
(CAIP) only. New users may be required to register to obtain access to
certain areas of the site (including the FTP site).

Physical Description

Active switches and spacers can be mixed and arranged as needed to suit
a particular application. LEDs along the side of the keypad identify the
active switches.
Each keypad has a mini Cresnet network port labeled 24 Y Z G. The port
provides for operating power and for communication to/from the keypad.
The button caps are tapered and are arranged in a shingle style with the
narrow part of the button cap at the top. Each button cap can, however,
be arranged in either orientation, and the overall keypads can be installed
with the LEDs on the right. Spacers are flat and flush with the front of the
bezel surface. Button caps are laser-engravable using the Crestron
Engraver software; spacers are not. The engraving software provides up
to three fields for each button cap to allow for the left/right and center
press functions, permits multiple lines of text, and also allows you to
specify the orientation of each button cap. The Crestron Engraver
software, Version 2.4 or later, is available from the Crestron website.
NOTE: A single button cannot be installed in the lowest position of the
keypad.
The following illustrations provide overall dimensions of the three
keypad styles.
4 • Cameo Keypads: C2N/C2NI-CB Series
Crestron C2N/C2NI-CB Series
Operations & Installation Guide - DOC. 6346C