Table of Contents
Advertisement
Switch Manager
Load Firmware dialog box messages
Table 34: Load Firmware dialog box messages
Bad checksum/CRC for the firmware image or
incorrect firmware image for this type of
switch.
File was not found.
Firmware image had a bad CRC or was
invalid for this type of switch.
Firmware upload status unknown. Image has
been uploaded, but confirmation from the
switch was not received.
The flash memory on the switch may be too
small for this image.
Unable to load firmware.
Unable to read file.
Port Loopback Test dialog box messages
Table 35: Port Loopback test dialog box messages
Attempt to put port in diagnostic state has
failed. Unable to continue with port test.
External port test requires a loopback device
be plugged into the selected port. Click "OK"
when loopback device is installed.
Failed to correctly restore port states for one or
more ports.
Invalid frame count value.
or
Invalid frame size. Must be 36 to 2148.
or
Invalid hex pattern. Up to 8 hex digits
allowed.
104
Message
Message
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
User action
Select the correct firmware file for this switch.
Verify that the firmware file specified actually
exists, or specify a new firmware file.
Select a valid firmware image for this type of
switch and retry the operation.
The application lost communications with the
switch while the switch was unpacking the
firmware image. If the problem was
temporary, examine the firmware versions on
the switch to verify that the firmware was
unpacked correctly, or upload a new firmware
image to the switch.
Select an appropriate firmware image for this
type of switch and retry the operation.
An unspecified error has occurred. Verify that
the user has permissions to modify the
configuration on the switch, that the switch is
reachable in the fabric, and that the fabric is
reachable from the user's workstation, and
then retry the firmware upload.
Verify that the firmware file specified exists
and is readable by the user, on a file system
readable by the user, or specify a new
firmware file.
User action
Verify that the user has permissions to modify
the configuration on the switch, that the switch
is reachable in the fabric, and that the fabric is
reachable from the user's workstation, and
then retry the configuration change.
Verify that a loopback device is attached to the
port before starting loopback test.
Return to the faceplate view and then select
View>Port State to determine which port was
not restored to its original state. Select the
port, and then select Port>Port Properties to
restore the port state.
Verify that all information is valid, and then
retry the loopback test.
Advertisement
Table of Contents
