HP 2/8q Fibre Channel User Manual page 156

Command Line Interface
The following is an example of the Show NS [port_ID] command:
The following is an example of the Show Interface command:
156
2/8q FC Switch #> show ns 1301e1
Port ID: 1301e1
--------
PortType
PortWWN
SymbolicPortName
NodeWWN
SymbolicNodeName
NodeIPAddress
ClassOfService
PortIPAddress
FabricPortName
FC4Type
FC4Desc
2/8q FC Switch #> show interface
eth0 Link encap:Ethernet
inet addr:10.20.68.107
UP BROADCAST RUNNING MULTICAST
RX packets:4712 errors:0 dropped:0 overruns:0 frame:0
TX packets:3000 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:415313 (405.5 Kb)
Interrupt:11 Base address:0xfcc0
lo Link encap:Local Loopback
inet addr:127.0.0.1
UP LOOPBACK RUNNING
RX packets:304 errors:0 dropped:0 overruns:0 frame:0
TX packets:304 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:20116 (19.6 Kb)
NL
21:00:00:20:37:73:13:69
20:00:00:20:37:73:13:69
0.0.0.0
3
0.0.0.0
20:01:00:c0:dd:00:bc:56
FCP
(NULL)
HWaddr 00:C0:DD:00:BD:ED
Bcast:10.20.68.255
TX bytes:716751 (699.9 Kb)
Mask:255.0.0.0
MTU:16436
TX bytes:20116 (19.6 Kb)
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Mask:255.255.255.0
MTU:1500 Metric:1
Metric:1