Set Config Switch Parameters - HP 2/8q Fibre Channel User Manual

Table 51: Set Config port parameters (Continued)
NoClose
IOStreamGuard
VIEnable
PDISCPingEnable
Table 52: Set config switch parameters
AdminState
BroadcastEnabled
DefaultDomainID
DomainIDLock
SymbolicName
R_A_TOV
E_D_TOV
PrincipalPriority
ConfigDescription
InteropMode
LegacyAddressFormat
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Parameter
SWITCH
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value. For
each parameter, enter a new value or press Enter to accept the current value shown in
brackets. Table 52 describes the Set Config Switch parameters.
Parameter
Description
Loop circuit closure prevention. Enables (True) or disables
(False) the loop's ability to remain in the open state
indefinitely. True reduces the amount of arbitration on a loop
when there is only one device on the loop. The default is
False.
I/O Stream Guard. Enable (Enable) or disables (Disable) the
suppression of RSCN messages. I/O Stream Guard should be
enabled only for ports connected to initiator devices. The
default is Disable.
Enables (True) or disables (False) VI preference routing. The
default is False. Enabling VIEnable will disable MFSEnable.
Enables (True) or disables (False) the transmission of ping
messages from the switch to all devices on a loop port. The
default is True.
Description
Switch administrative state: online, offline, or diagnostics. The
default is Online.
Broadcast. Enables (True) or disables (False) forwarding of
broadcast frames. The default is True.
Default domain ID. The default is 1.
Prevents (True) or allows (False) dynamic reassignment of the
domain ID. The default is False.
Descriptive name for the switch. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is 2/8q FC Switch.
Resource Allocation Timeout Value. The number of
milliseconds the switch waits to allow two ports to allocate
enough resources to establish a link. The default is 10000.
Error Detect Timeout Value. The number of milliseconds a port
is to wait for errors to clear. The default is 2000.
The priority used in the FC-SW-2 principal switch selection
algorithm. 1 is high, 255 is low. The default is 254.
Switch configuration description. The configuration description
can be up to 32 characters excluding #, semicolon (;), and
comma (,). The default is 2/8q FC Switch.
Propagates just the active zone set throughout the fabric (True,
compliant) or the entire zoning database (False,
non-compliant). The default is True. (not supported)
Available only when the InteropMode parameter is False, this
parameter enables (True) or disables (False) the use of legacy
address formatting for interoperating with non-FC-SW-2
switches. See Table 52. The default is False. (not supported)
Command Line Interface
139