Show Port Parameters - HP 2/8q Fibre Channel User Manual

Command Line Interface
Table 57: Show Port parameters
AIinit
AIinitError
Bad Frames
ClassXFramesIn
ClassXFramesOut
ClassXWordsIn
ClassXWordsOut
ClassXToss
DecodeError
FBusy
Flowerrors
FReject
InvalidCRC
InvalidDestAddr
LIP_AL_PD_ALPS
LIP_F7_AL_PS
LIP_F8_AL_PS
LIP_F7_F7
LIP_F8_F7
152
[port_id]—Displays name server information for the port given by [port_id].
[port_id] is a port Fibre Channel address.
pagebreak
Displays the current pagebreak setting. The pagebreak setting limits the display of
information to 20 lines (On) or allows the continuous display of information without a
break (Off).
perf [option]
Displays performance information for all ports. See the
page 165.
port [port_number]
Displays operational information for the port given by [port_number]. Ports are
numbered beginning with 0. If [port number] is omitted, information is displayed for
all ports. Table 57 describes the port parameters.
Entry
Incremented each time the port begins AL initialization.
Number of times the port entered initialization and the
initialization failed.
Number of frames that have framing errors.
x
Number of class frames received by this port.
x
Number of class frames sent by this port.
x
Number of class words received by this port.
x
Number of class words sent by this port.
Number of times an SOFi3 or SOFn3 frame is tossed from
TBUF.
Number of decode errors detected
Number of class 3 fabric busy (F_BSY) frames generated by
this port in response to incoming frames. This usually indicates
a busy condition on the fabric or N_Port that is preventing
delivery of this frame.
Received a frame when there were no available credits.
Number of frames from devices that were rejected.
Invalid CRC detected.
Invalid destination address detected.
Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets,
performed.
This LIP is used to reinitialize the loop. An L_Port, identified by
AL_PS, may have noticed a performance degradation and is
trying to restore the loop.
This LIP denotes a loop failure detected by the L_Port identified
by AL_PS.
A loop initialization primitive frame used to acquire a valid
AL_PA.
A loop initialization primitive frame used to indicate that a
loop failure has been detected at the receiver.
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
"Show Perf command" on
Description