Set Command; Authority; Syntax; Keywords - HP 2/8q Fibre Channel User Manual

Table 49: SNMP configuration default settings (Continued)
Object ID
AuthFailureTrap
ProxyEnabled
Table 50: System configuration default settings
Ethernet Network Discovery
Ethernet Network IP Address
Ethernet Network IP Mask
Ethernet Gateway Address
Admin Timeout
LocalLogEnabled
RemotelogEnabled
RemoteLogHostAddress
NTPClientEnabled
NTPServerAddress

Set command

Sets a variety of switch parameters.

Authority

Syntax

Keywords

HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Parameter
Parameter
Admin for all keywords except Alarm, Beacon, and Pagebreak.
SET
ALARM [option]
Controls the display of alarms in the session output stream or clears the alarm log.
[option] can be one of the following:
CLEAR—Clears the alarm log history. This value requires an Admin session.
ON—Enables the display of alarms in the session output stream.
OFF—Disables the display of alarms in the session output stream.
BEACON [state]
Enables or disables the flashing of the Logged-In LEDs according to [state]. This
keyword does not require an admin session. [state] can be one of the following:
ON—Enables the flashing beacon.
OFF—Disables the flashing beacon.
Default setting
1.3.6.1.4.1.1663.1.1.1.1.31
False
True
Default setting
Static
10.0.0.1
255.0.0.0
10.0.0.254
30 minutes
True
False
10.0.0.254
False
10.0.0.254
Command Line Interface
135