Port Statistics Data Window Entries - HP 2/8q Fibre Channel User Manual

Table 23: Port Statistics data window entries (Continued)
FBusy
Flow Errors
FReject
Invalid CRC
Invalid Destination
Address
Link Failures
LIP (AL_PD,AL_PS)
LIP(f7,AL_PS)
LIP(f7,f7)
LIP(f8,AL_PS)
Login Count
Logout Count
Loop Timeouts
Loss Of Sync
Primitive Sequence
Errors
Rx Link Resets
Rx Offline Sequences
Total Errors
Total Link Resets
Total LIPs Received
Total LIPs Transmitted
Tx Offline Sequences
Total Rx Frames
Total Rx Words
Total Tx Frames
Total Tx Words
Tx Link Resets
Total Offline
Sequences
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Entry
Number of class 3 fabric busy (F_BSY) frames generated by this port
in response to incoming frames. This usually indicates a busy condition
on the fabric or N_port that is preventing delivery of this frame.
Number of times a frame is received and all the switch ports receive
buffers are full. The normal Fabric Login exchange of flow control
credit should prevent this from occurring. The frame is discarded.
Number of frames, from devices, that have been rejected. Frames can
be rejected for any of a large number of reasons.
Number of invalid Cyclic Redundancy Check (CRC) frames detected.
Number of address identifier (S_ID, D_ID) errors. AL_PA equals
non-zero AL_PA found on F_Port.
Number of optical link failures detected by this port. A link failure is a
loss of synchronization or by loss of signal while not in the offline
state. A loss of signal causes the switch to attempt to re-establish the
link. If the link is not re-established, a link failure is counted. A link
reset is performed after a link failure.
Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets
performed.
Used to reinitialize the loop. An L_port, identified by AL_PS, may have
noticed a performance degradation and is trying to restore the loop.
A loop initialization primitive frame used to acquire an AL_PA.
Denotes a loop failure detected by the L_port identified by AL_PS.
Number of device logins that have occurred on the switch.
Number of device logouts that have occurred on the switch.
Number of loop timeouts.
Number of synchronization losses (>100 ms) detected by this port. A
loss of synchronization is detected by receipt of an invalid
transmission word.
Number of bad primitives received by the port.
Number of link reset primitives received from an attached device.
Number of offline sequence primitives received by the port.
Total number of primitive and non-primitive port link errors.
Number of link-reset primitives the transmitted by the port.
Number of loop initialization primitive frames received.
Number of loop initialization primitive frames transmitted.
Number of offline primitives transmitted by the port.
Total number of frames received by the port.
Total number of words received by the port.
Total number of frames transmitted by the port.
Total number of words transmitted by the port.
Number of link reset primitives sent from this port to an attached port.
Total number of offline sequences transmitted and received by the
port.
Description
Switch Manager
83