Hardreset Command; Examples; Authority; Syntax - HP 2/8q Fibre Channel User Manual

Command Line Interface

Examples

Hardreset command

Resets the switch and performs a power-on self test. This reset disrupts traffic, activates the
pending firmware, and clears the alarm log. To save the alarm log before resetting, refer to the
"Set Log

Authority

Syntax

Notes

124
2/8q FC Switch (admin) #> firmware install
Warning: Installing new firmware requires a switch reset.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
User Account : johndoe
IP Address : 10.20.33.130
Source Filename : 4.0.3.04.00_mpc
About to install image.
Connected to 10.20.33.130 (10.20.33.130).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
Command" on page 144.
Admin
HARDRESET
To reset the switch without a power-on self test, refer to the
page 131.
Do you want to continue? [y/n] y
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
"Reset command" on