Hinge Adjustment - Wells WVOC-2HFG Owner's Manual

MAINTENANCE INSTRUCTIONS (continued)
CAUTION:
BURN HAzARD
Allow appliance to cool
completely before adjusting.
B O T TO M
PA N E L

Hinge Adjustment

HINGE ADjUSTMENT
PRECAUTIONS:
None
Monthly, at a Minimum; or, As Needed
FREQUENCY:
TOOLS:
Phillips (+) Screwdriver
7/16" Nut Driver
7/8" and 1-1/8" Wrenches
THE FOLLOWING PROCEDURE IS TO BE PERFORMED
BY QUALIFIED PERSONNEL ONLY
1. Remove bottom panel to access pivot.
2. Gap between top of door and frame , and between bottom
of door and frame must be approximately equal
Adjust height of door by loosening jamb nut, then turning pivot on its
screw mounting. Clockwise lowers the door height.
Re-tighten jamb nut .
3. Gap between left side of door and frame must be the
same from top to bottom
Adjust door for plumb by loosening holding screws. Turn
adjusting bolt to increase or decrease gap at bottom.
Clockwise increases gap. Re-tighten holding screws.
4. Gap between top of door and frame must be the same
from side to side
Adjust door for level by loosening holding screws, then raising or
lowering latch-end of door until it is level. Re-tighten holding screws.
5. Reinstall bottom panel.
Procedure is complete
24