Hinge Adjustment - Wells M42004 Owner's Manual

HINGE ADJUSTMENT

ALLOW THE UNIT TO COOL COMPLETELY BEFORE
PERFORMING ADJUSTMENT PROCEDURE.
TOOLS REQUIRED
i. Phillips screwdriver
ii. 7/16 in. nut driver
iii. 7/8 in. open end wrench
iv. 1-1/8 in. open end wrench
v. tape measure or other measuring device [optional]
ADJUSTMENT PROCEDURE
This procedure should only be performed by qualified
personnel only. The door can be adjusted on the lower
left in order to affect its level, plumb, and height relative
to the frame.
i. Begin by checking the door to determine what
adjustments need to be made.
ii. Remove the lower, front trim.
iii. If the gaps between the top and the bottom of the door
relative to the frame are not approximately equal, the
height will need to be adjusted. Begin by loosening jamb
nut, then turn the shaft clockwise to lower the door and
counterclockwise to raise the door. Adjust until the door
is level, then tighten the jamb nut when finished.
iv. Looking at the left side of the oven, if the gap between
the door and the frame is not equal at the top and bottom
of the door, the plumb of the door will need to be adjusted.
Begin adjusting the door by loosening the holding screws
on either side of the adjusting bolt. Next, turn the adjusting
bolt to clockwise to increase the gap or counterclockwise
to decrease the gap at bottom of the door. Once the bottom
gap is equal to the top, tighten the holding screws back
in place.
v. If the gap between the top of door and the frame is not
even from side to side, the level of the door will require
adjustment. In order to adjust, loosen the holding screws,
then raise or lower right [latch] side of door until it is level.
Tighten the holding screws once the door is level.
vi. Once all adjustments are made, replace the front, lower trim.
21