Advanced Settings/Video Settings; Firmware Version 1.0.1.20 - Grandstream Networks GXV3275 Administration Manual

Disable Conference
Disable Transfer
Default Transfer Mode
Escape # as %23 in SIP URI
Offhook Auto Dial
Offhook Timeout (s)

ADVANCED SETTINGS/VIDEO SETTINGS

Video Frame Rate
Display Video Information
Enable Frame Skipping in
Video Decoder

Firmware Version 1.0.1.20

Disables the Conference function. The default setting is "No".
Disables the Transfer function. The default setting is "No".
Selects default transfer mode as "Blind Transfer" or "Attended Transfer".
The default setting is "Blind Transfer".
Replaces "#" by "%23" for some special situations. The default setting is
"Yes".
Configures a User ID/extension to dial automatically when the phone is
offhook. The phone will use the first account to dial out. The default
setting is "No".
If configured, when the phone is on hook, it will go off hook after the
timeout (in seconds). The default setting is 30. The valid range is from
10 to 60.
Configures video frame rate for SIP video call from "5 frames/second",
"15 frames/second", "25 frames/second", "30 frames/second" and
"Variable frames rate". The default setting is 15 frames/second. The
video frame rate is adjustable based on network conditions. Increasing
the frame rate will significantly increase the amount of data transmitted,
therefore consuming more bandwidth. The video quality will be affected
due to packet loss if extra bandwidth is not allocated.
Configure whether to display video stream sending and receiving
information during video call. The default setting is "No".
Configure to enable frame skipping in video decoder. If enabled, the
video decoder will skip the P frame and start decoding from the next I
frame. Enabling this option will help reduce flickering in the video when
the bandwidth is limited in the network environment. The default setting
is "Yes".
GXV3275 Administration Guide Page 51 of 77