Firmware Version 1.0.1.20 - Grandstream Networks GXV3275 Administration Manual

Refer-To Use Target Contact
Auto Answer
Send Anonymous
Anonymous Call Rejection
Call Log
Special Feature
Feature Key Synchronization

Firmware Version 1.0.1.20

Explanation of example rule (reading from left to right):

^1900x. - prevents dialing any number started with 1900

<=1617>[2-9]xxxxxx - allow dialing to local area code (617) numbers
by dialing 7 numbers and 1617 area code will be added
automatically

1[2-9]xx[2-9]xxxxxx |- allow dialing to any US/Canada Number with
11 digits length

011[2-9]x. - allow international calls starting with 011

[3469]11 - allow dialing special and emergency numbers 311, 411,
611 and 911
NOTE: In some cases where the user wishes to dial strings such as
*123 to activate voice mail or other applications provided by their service
provider, the * should be predefined inside the dial plan feature. An
example dial plan will be: { *x+ } which allows the user to dial * followed
by any length of numbers.
If set to "Yes", the "Refer-To" header uses the transferred target's
Contact header information for attended transfer. The default setting is
"No".
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep. If set to "Enable
Intercom/Paging", it will answer the call based on the SIP info header
sent from the server/proxy. The default setting is "No".
If set to "Yes", the "From" header in outgoing INVITE messages will be
set to anonymous, essentially blocking the Caller ID to be displayed.
The default setting is "No".
If set to "Yes", anonymous calls will be rejected. The default setting is
"No".
Configures Call Log setting on the phone. You can log all calls, log
incoming/outgoing calls (missed calls will not be logged), or disable call
log. The default setting is "Log All".
Different soft switch vendors have special requirements. Therefore users
may need select special features to meet these requirements. Users can
choose from Standard, Broadsoft, CBCOM, RNK, China Mobile, ZTE
IMS, Mobotix, ZTE NGN, or Huawei IMS depending on the server type.
The default setting is "Standard".
This feature is used for Broadsoft call feature synchronization. When it's
enabled, DND, Call Forward features and Call Center Agent status can
GXV3275 Administration Guide Page 46 of 77