Advanced Settings/Call Features; Firmware Version 1.0.1.20 - Grandstream Networks GXV3275 Administration Manual

STUN Server
Use NAT IP
SIP TLS Certificate
SIP TLS Private Key
SIP TLS Private Key Password

ADVANCED SETTINGS/CALL FEATURES

Always Ring Speaker
Auto Conference
Disable Call-Waiting
Disable DialPlan
Disable Call-Waiting Tone
Disable DND Reminder Ring
Disable Direct IP Call
Use Quick IP-Call mode

Firmware Version 1.0.1.20

default setting is 20 seconds. The valid range is from 10 to 160.
The IP address or Domain name of the STUN server. STUN resolution
results are displayed in the STATUS page of the Web GUI. Only
non-symmetric NAT routers work with STUN. The default setting is
"stun.ipvideotalk.com".
Specify the NAT IP address used in SIP/SDP messages. This field is
blank at the default settings. It should ONLY be used if it's required by
your ITSP.
SSL certificate used for SIP TLS Transport.
SSL Private key used for SIP TLS Transport.
SSL Private key password used for SIP TLS Transport.
This setting is used when the headset is connected. If set to "Yes", the
phone will always ring speaker when headset is used at the same time.
The default setting is "No".
If set to "Yes", users could press CONFERENCE button to establish
conference call when there are 2 or more calls on the phone, instead of
adding each party one by one. The default setting is "No".
Disables the call waiting feature. The default setting is "No".
Disables dial plan check on the GXV3275 when dialing out. This can be
used when dialing out phone number which contains alphabet
characters from imported contacts. The default setting is "No".
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disables the DND reminder ring. If set to "Yes", the ring splash that
indicates an incoming call when DND is enabled will not be played. The
default setting is "No".
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, offhook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
GXV3275 Administration Guide Page 50 of 77