Advanced Settings/Video Settings - Grandstream Networks GXV3275 Administration Manual

Disable Transfer
Default Transfer Mode
Escape # as %23 in SIP URI
Offhook Auto Dial
Offhook Auto Dial Delay (s)
Offhook Timeout (s)
Enable Function for
Incoming Call
Call Function Buttons

Advanced Settings/Video Settings

Video Frame Rate
Display Video Information
Disables the transfer feature. When set to "Yes", the phone system will block the
TRANSFER key on the LCD screen. The default setting is "No".
Sets the default transfer mode for the phone system. If the Blind Transfer or
Attended Transfer mode is set, the phone system will use the specific mode to
transfer an active call. The users still have privilege to switch the mode on the LCD
screen when they tap the transfer key. The default setting is "Blind Transfer".
Determines which characters will be included in the SIP INVITE URI if end users
input #. If it is set to "Yes", the phone system will replace the # by %23. Otherwise,
it will include # in the SIP INVITE message.
The default setting is "Yes".
Configures the User ID/extension to dial automatically when the phone is off-hook.
The phone will use the first account to dial the configured numbers out. The default
setting is "No".
Defines the timer for warm line dialing. After the timer expires, the phone system
will dial the configured number in Off-hook Auto Dial automatically. If it is not
configured, the configured number will be dialed immediately.
Sets the timer for off hook. The phone system will be automatically on hook if users
pick up the handset or turn on the speaker, and do not take any actions before the
off-hook timeout expired (in seconds). The default setting is 30. The valid range is
from 10 to 60.
Enables the preview feature for the incoming video calls. Defines the function for
the incoming video call. If it is set to "Preview", the phone system will pop up the
PREVIEW key on the LCD screen when there is an incoming video call, and users
could tap on it to check video caller without answering the incoming video call.
The default setting is "None".
Configures the buttons displayed on call screen. You can select three options at
most. If select less than three options, it will automatically display the unchecked
options in sequence behind the selected ones. The default setting is "Hold", "Mute"
and "Keyboard".
Note: The settings will not take effect immediately during the call.
Configures video frame rate for SIP video call from "5 frames/second", "15
frames/second", "25 frames/second", "30 frames/second" and "Variable frames
rate". The default setting is 15 frames/second. The video frame rate is adjustable
based on network conditions. Increasing the frame rate will significantly increase
the amount of data transmitted, therefore consuming more bandwidth. The video
quality will be affected due to packet loss if extra bandwidth is not allocated.
Sets the phone system to display the video stream sending and receiving
information during a video call. The default setting is "No".
GXV3275 Administration Guide
P a g e | 61