Advanced Settings/Call Features - Grandstream Networks GXV3240 Administration Manual

ADVANCED SETTINGS/CALL FEATURES

Always Ring Speaker
Auto Conference
Disable Call-Waiting
Disable DialPlan
Disable Call-Waiting Tone
Disable DND Reminder Ring
Disable Direct IP Call
Use Quick IP-Call mode
Disable Conference
Disable Transfer
Default Transfer Mode
Escape # as %23 in SIP URI
Offhook Auto Dial
Offhook Timeout (s)
Firmware Version 1.0.1.27
This setting is used when the headset is connected. If set to "Yes", the
phone will always ring speaker when headset is used at the same time.
The default setting is "No".
If set to "Yes", users could press CONFERENCE button to establish
conference call when there are 2 or more calls on the phone, instead of
adding each party one by one. The default setting is "No".
Disables the call waiting feature. The default setting is "No".
Disables dial plan check on the GXV3240 when dialing out. This can be
used when dialing out phone number which contains alphabet
characters from imported contacts. The default setting is "No".
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disables the DND reminder ring. If set to "Yes", the ring splash that
indicates an incoming call when DND is enabled will not be played. The
default setting is "No".
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, offhook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disables the Conference function. The default setting is "No".
Disables the Transfer function. The default setting is "No".
Selects default transfer mode as "Blind Transfer" or "Attended Transfer".
The default setting is "Blind Transfer".
Replaces "#" by "%23" for some special situations. The default setting is
"Yes".
Configures a User ID/extension to dial automatically when the phone is
offhook. The phone will use the first account to dial out. The default
setting is "No".
If configured, when the phone is on hook, it will go off hook after the
timeout (in seconds). The default setting is 30. The valid range is from
10 to 60.
GXV3240 Administration Guide Page 48 of 76