Caster Cart Installation - Powerware 9170 User Manual

Installation Setup

Caster Cart Installation

An optional caster cart (ASY-0527) is available for 3- and 6-slot cabinets
for increased mobility of the UPS (see Figure 7).
NOTE
lift and position the cabinet onto the caster cart. Lift the cabinet using
four lifting straps shipped with the cabinet; do not attempt to lift the
cabinet by the module shelves or other convenient edges or panels.
Figure 7. Three-Slot Cabinet Being Lowered onto Caster Cart
1.
2.
3.
10
The UPS cabinet is heavy. This procedure requires two people to
Caster Cart
Place the caster cart (shipped separately from the UPS cabinet)
under the cabinet before installing power and battery modules
and before making connections to the intended power source.
The cart requires no bolts or other hardware to fasten it to the
UPS cabinet. It is shaped to fit securely under the cabinet,
ensuring proper alignment after placing the cabinet on the cart.
Four foot pads under the cart keep the cart from rolling when it
is in its intended location. Turn each threaded foot to lower it
to the floor. When the foot is tight against the floor, turn the
lock nut on the threaded foot up tight against the bottom of
the cart to keep the foot from rotating.
If leveling of the UPS is required, use the foot pads to raise a
side or corner before locking them with their lock nuts.
+
Powerware 9170 UPS User's Guide
®
Rev B www.powerware.com
S