Nine- And Twelve-Slot Cabinets - Powerware 9170 User Manual

3.

Nine- and Twelve-Slot Cabinets

NOTE
output is shipped with two stabilizer brackets. These brackets must be
attached to the wall or the floor behind the UPS cabinet (see page 11).
Do NOT lower the casters or attempt to move the cabinet with the power or
battery modules installed.
1.
2.
3.
NOTE
need to place a thin steel plate under a corner.
bolts to level the cabinet.
4.
+
Powerware 9170 UPS User's Guide
®
If you are installing an external battery cabinet, continue to
"Battery Cabinet Installation" on page 57.
If you do not have an external battery cabinet, continue to "UPS
Startup" on page 63 for plug-receptacle units. For hardwired
units, continue to "UPS with Bypass Electrical Installation" on
page 19 or "UPS Electrical Installation" on page 37.
The 12-slot Powerware 9170
C A U T I O N
Lower the four cabinet casters (one at each corner of the
cabinet base) by using a 1/2I hex-style socket wrench to turn
each bolt clockwise.
With all casters fully extended, carefully roll the cabinet down
the ramp and to its intended operating location.
To stabilize the cabinet in its operating location, turn the four
caster bolts counter-clockwise until the cabinet rests on the
floor. Place a plastic cap into each bolt access hole.
If the floor is uneven and the cabinet is tilted or unstable, you may
If you are installing an external battery cabinet, continue to
"Battery Cabinet Installation" on page 57.
If you do not have an external battery cabinet, continue to "UPS
Startup" on page 63 for plug-receptacle units. For hardwired
units, continue to "UPS with Bypass Electrical Installation" on
page 19 or "UPS Electrical Installation" on page 37.
Rev B www.powerware.com
S
Installation Setup
+
UPS cabinet with non-isolated
Do not use the caster
9