Battery Test; Menu Map - Powerware 9170 User Manual

Operation
Table 12 contains a description of all alarm log messages.
Table 12. Alarm Log Messages
Message
Open Cell
Weak Battery
Phase Error
Module Failure
Excessive Transfers
Precharge Failure
Insufficient Batteries
Insufficient Modules
Incompatible
Module

Battery Test

NOTE
been on battery within 24 hours of the battery test.
The Powerware 9170
30 days by default and can also be performed manually.
The battery test parameters, including the test interval and time of day,
can be set up in menu 3, submenu 1. To initiate a manual test, select
menu 3 1 1. When the test is complete, the UPS automatically provides
the results on the screen.

Menu Map

Figure 60 is an illustration of how to access all Powerware 9170
parameters. The menu structure has 6 primary-level menus, named
System Status Menu (1) through Service Menu (6). Under each primary
menu are secondary items, each numbered by its location under the
primary menu. Use the various buttons as shown in the map to navigate
to the desired parameter.
84
Explanation
Battery failure caused by open cell.
Battery failure caused by load test.
Internal error – contact your service representative.
Internal error – contact your service representative.
Internal error – contact your service representative.
Internal error – contact your service representative.
Too few battery modules; decrease load or add battery
modules.
Too few power modules; decrease load or add power
modules.
A power module with incompatible firmware has been
installed in the system; contact your service representative.
The batteries must be fully charged and the UPS must not have
+
has a battery test that runs automatically every
+
Powerware 9170 UPS User's Guide
®
+
system
Rev B www.powerware.com
S