Configuration Overview - HP StorageWorks N1200 User Manual

Configuration Overview

The HP StorageWorks Network Storage Router can be configured and managed
using several user interfaces (UI). Each UI is introduced in this chapter, along
with information about common configuration settings.
Included are:
Note:
SCSI devices is recommended. For information on SCSI standards, refer to publications from the
X3T10 committee of ANSI (American National Standards Institute). For information on Fibre
Channel standards, refer to publications from the X3T11 committee of ANSI. For those who are
interested in purchasing approved American National Standards and Technical Reports, contact
ANSI at (212) 642-4900.
Network Storage Router N1200 User Guide
Router Default Ethernet
UI Overview, page 29
Common Configuration
— Controller LUN Commands
— SCSI Bus Configuration
— Fibre Channel Port Configuration
— Fibre Channel Arbitrated Loop Configuration
— Fibre Channel Switched Fabric Configuration
— Discovery Mode
— Host Device Configuration
— Logical Unit Management
— Buffered Tape Writes
Before attempting to configure the router, a basic understanding of Fibre Channel and
Settings, page 28
Settings, page 31
2
27