Configuration Overview - HP StorageWorks e1200-160 User Manual

Configuration Overview

The HP StorageWorks Network Storage Router can be configured and managed
using several user interfaces (UI). Each UI is introduced in this chapter, along
with information about common configuration settings. Included are:
Note:
SCSI devices is recommended. For information on SCSI standards, refer to publications from the
X3T10 committee of ANSI (American National Standards Institute). For information on Fibre
Channel standards, refer to publications from the X3T11 committee of ANSI. For those who are
interested in purchasing approved American National Standards and Technical Reports, contact
ANSI at (212) 642-4900.
Network Storage Router e1200-160
Router Default Ethernet
UI Overview, page 27
Common Configuration
— Controller LUN Commands
— SCSI Bus Configuration
— Default Fibre Channel Port Configuration
— Fibre Channel Switched Fabric Configuration
— Discovery Mode
— Host Device Configuration
— Logical Unit Management
— Buffered Tape Writes
Before attempting to configure the router, a basic understanding of Fibre Channel and
2F
Settings, page 26
Settings, page 29
2
25