Cables; Power Cords - HP StorageWorks N1200 User Manual

Regulatory Compliance Notices

Cables

Connections to this device must be made with shielded cables with metallic
RFI/EMI connector hoods in order to maintain compliance with FCC Rules and
Regulations.

Power Cords

The power cord set included in your server meets the requirements for use in the
country where you purchased your server. If you need to use this server in another
country, you should purchase a power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current
marked on the product's electrical ratings label. The voltage and current rating of
the cord should be greater than the voltage and current rating marked on the
product. In addition, the cross sectional area of the wire must be a minimum of
1.00 mm² or 18AWG, and the length of the cord must be between 6 feet (1.8 m)
and 12 feet (3.6 m). If you have questions about the type of power cord to use,
contact your HP authorized service provider.
A power cord should be routed so that it is not likely to be walked on or pinched
by items placed upon it or against it. Particular attention should be paid to the
plug, electrical outlet, and the point where the cord exits from the product.
178
WARNING: This product can ONLY be used with an HP approved power cord
for your specific geographic region. Use of a non-HP approved power cord
may result in: 1) not meeting individual country specific safety requirements;
2) insufficient conductor ampacity that could result in overheating with
potential personal injury and/or property damage; and 3) an unapproved
power cord could fracture resulting in the internal contacts being exposed,
which potentially could subject the user to a shock hazard. HP disclaims all
liability in the event a non-HP approved power cord is used.
Network Storage Router N1200 User Guide