Controller LUN Commands
Copy Manager Commands
To access Copy Manager or other general management features, the commands
must be sent to the router controller LUNs. The following controller LUN
commands can be used for Copy Manager on the router:
Each of these commands is discussed in the following paragraphs.
Extended Copy Command
The router supports Extended Copy commands in the following two formats:
To initiate Extended Copy operations, the commands can be sent to any tape
device LUN attached to the router. Multiple concurrent Extended Copy
commands can be active.
Version 99-143r1
The Extended Copy command supports the following Target descriptor codes
listed in
Table 19: Extended Copy Target descriptor codes, version 99-143r1
Fibre Channel World Wide Name
Target Descriptor
Fibre Channel N_Port Target
descriptor
166
Extended Copy
Receive Copy Results
Mode Sense (6) and Mode Sense (10)
Version 99-143r1
Version SPC-2
Table
19:
Item
Value
0xE0
0xE1
Network Storage Router N1200 User Guide