Router Default Ethernet Settings - HP StorageWorks N1200 User Manual

Configuration Overview

Router Default Ethernet Settings

Some of the basic factory default values are:
HP recommends that you change these values from the defaults.
All settings within the router configuration are preset with default values. These
values are set to allow the router to be installed into most HP environments with
little or no configuration changes.
After changing the basic default values listed above, carefully consider any
additional configuration changes.
After the initial configuration of the router is established, HP recommends
backing up the configuration to an external file. If needed, during a recovery
process, this file can then be restored back onto the router.
28
IP address:
http://1.1.1.1/
Subnet mask:
255.255.255.0
Gateway address:
0.0.0.0
User name:
root
Password:
password
Network Storage Router N1200 User Guide