Table of Contents
Advertisement
Setting the Button Background Illumination
The buttons on the front panel can be set to have amber background illumination at all
times or the background illumination can be turned off.
To toggle the background illumination on and off, press and hold the Input 1 and Input 2
buttons simultaneously until the button background illumination changes (approximately
2 seconds.
Press and hold the Input 1 and Input 2 buttons
simultaneously to toggle background illumination
mode on or off.
After approximately 2 seconds, release
the Input 1 and Input 2 buttons.
Figure 63.
Selecting the RS-232/RS-422 Port Protocol and Baud Rate (Rear Panel)
The DXP switchers can support either RS-232 or RS-422 serial communication protocol,
and can operate at 9600, 19200, 38400, and 115200 baud rates. The settings of these
variables can be viewed and changed from the front panel.
NOTE:
View and configure the switcher serial communications settings as follows:
1.
2.
INPUTS
1
2
3
4
5
6
1
2
3
4
5
6
OUTPUTS
Toggle Background Illumination On or Off
•
The Remote RS232/RS422 port settings are protected when front panel lock
mode 2 is selected. You can view the settings in lock mode 2 but you cannot
adjust them from the front panel (see
Panel (Executive
•
To enable changes to the RS-232 or RS-422 settings, set the lock mode to
.
0
To enter serial port configuration mode, simultaneously press and hold all four control
buttons (Enter, Preset, View, and Esc) until they all light, with one blinking.
Press and hold the Enter, Preset,
View, and Esc buttons.
C O N T R O L
2 seconds
VIEW
ESC
ENTER
PRESET
Figure 64.
RS-232 or RS-422 Baud Rate Display
Release the Control buttons.
DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation
7 8
7
8
"Locking and Unlocking the Front
Modes)" on page 39).
C O N T R O L
VIEW
ESC
ENTER PRESET
All Control buttons light with
one flashing.
The Control button that continues flashing indicates the baud rate
as follows:
Enter — 9600
Preset — 19200
View — 38400
Esc — 115200
The I/O button that continues flashing indicates the protocol as
follows:
Video — RS-232
Audio — RS-422
In this example, the port is set to RS-232 at 9600 baud.
I / O
VIDEO
AUDIO
Both I/O buttons light
with one flashing.
44
Advertisement
Table of Contents
