To Use Event Input
4-5-3
Setting by key operation
4-5-4
Setup
To select set points (0/1/2/3)
Operation Procedure
50
Note Event input can be used when the option event input unit E53-
CNHB is mounted in the E5CN. Select event input ON/OFF while
the E5CN is turned ON. Judgment of event input ON/OFF is carried
out on event inputs of 50 ms or more.
You can select set points 0 to 3 by changing the set value of the "multi-SP"
parameter. The "multi-SP" display conditions are as follows:
• When the option event input unit E53-CNHB is not mounted in the E5CN,
and "multi-SP" is set to "ON"
• When the option event input unit E53-CNHB is mounted in the E5CN, the
"number of multi-SP uses" is set to "0" and "multi-SP" is set to "ON"
The following table shows the relationship between the "multi SP" parameter
set value and the selected set point.
Multi-SP
0
1
2
3
Before you set the "number of multi SP uses," cancel protection and move to
the "advanced function setting level". For details on how to cancel protection,
see "4.9 Using the Key Protect Level".
Selected Set Point
Set point 0
Set point 1
Set point 2
Set point 3
Section 4-5