Setting Multi-Sp; Setting Multi Sp; Setting The Sp By Key Operation; Setup - Omron E5GN User Manual

4.5 Setting Multi-SP

JSetting the SP by
key operation
JSetup
Operation Procedure
protect level
Operation
/adjustment
protection
Initial setting/
communica-
tions protec-
tion
Initial setup/
communica-
tions protec-
tion
Operation level
PV/SP
Initial setting level
Advanced function
setting level
Initial setting level
Operation level
You can select set points 0 to 3 by changing the set value of the multi SP"
parameter. The multi SP" display conditions are as follows:
The following table shows the relationship between the multi SP"
parameter set value and the selected set point.
Multi-SP
0
1
2
3
Before you set the Multi SP", cancel protection and move to the
advanced function setting level".
Set Multi SP uses" to ON in the advanced function setting level.
In the following example, let's set the set point to 2".
(1) Press the key and
seconds to move from the operation level" to the protect level".
(2) Select initial setting/communecations protection" by pressing the
key.
(3) Set the parameter to 0" (move to advanced function setting level
enabled).
(4) Press the key and
to move from the protect level" to the operation level".
(5) Press the key for at least three seconds to move to the initial set
ting level".
(6) Select move to advanced function setting level" by pressing the
key.
(7) Press the key to enter the  169" (password).
(8) Select Multi SP uses" by pressing the
Set the parameter to ON.
(9) Press the key for at least one second to move to the initial setting
level".
(10) Press the key for at least one second to move to the operation
level".
Selected Set Point
Set point 0
Set point 1
Set point 2
Set point 3
key simultaneously for at least three
key simultaneously for at least one second
key.
Setting Multi-SP 4.5
4–11