Omron E5CN User Manual page 104

Advanced Function Setting Level
See
Alarm 1 hysteresis
Function
Setting
See
Alarm 2 hysteresis
Function
Setting
See
94
Related parameters
"Alarm value 2" "Upper-limit alarm value 2" "Lower-limit alarm value 2" (opera-
tion level)
"Alarm 2 type" (initial setting level)
"Alarm 2 hysteresis" "Standby sequence reset method", "Alarm 2 latch"
(advanced function setting level)
• This parameter sets the hysteresis of alarm output 1.
• During analog input, the decimal point setting follows the "decimal point
position" setting.
Setting Range
0.1 to 999.9
Related parameters
"Alarm value 1" "Upper-limit alarm value 1" "Lower-limit alarm value 1" (opera-
tion level)
"Alarm 1 type" "Standard/heating and cooling" (initial setting level)
"Alarm 1 open in alarm" "Standby sequence reset method", "Alarm 1 latch"
(advanced function setting level)
• This parameter sets the hysteresis of alarm output 2.
• During analog input, the decimal point setting follows the "decimal point
position" setting.
Setting Range
0.1 to 999.9
Related parameters
"Alarm value 2" (operation level)
"Upper-limit alarm value 2" "Lower-limit alarm value 2" (operation level)
"Alarm 2 type" (initial setting level)
"Alarm 2 open in alarm" "Standby sequence reset method", "Alarm 2 latch"
(advanced function setting level)
Alarm 1 function must be supported.
Unit Default
EU 0.2
Alarm 2 function must be supported.
Control must be set to standard con-
trol.
Unit Default
EU 0.2
Section 5-6