Setting The Sp; Changing The Sp - Omron E5CN User Manual

Setting the SP

3-6

Setting the SP

Operation level
3-6-1

Changing the SP

Operation Procedure
1,2,3...
Operation level
The "operation level" is displayed when the E5CN is turned ON. The upper
display (No.1 display) displays the process value, and the lower display (No.2
display) displays the set point.
• The set point cannot be changed when the "operation/adjustment protec-
tion" parameter is set to "3". For details, see "4.9 Using the Key Protect
Levels."
• To change the set point, press the
parameter (operation level), and set the desired set value. The new set
point is selected two seconds after you have specified the new value.
• Multi-SP is used to switch between two or four set points.
See "4.5 To Use Event Input" for details.
In this example, let's change the set point from "0 ° C" to "200 ° C".
1. Normally, the "PV/SP" parameter is displayed. The set point is "0 ° C".
2. Press the or
or
keys until the set point changes to "200 ° C".
Section 3-6
keys in the "PV/SP"
25