Initial Setup Examples - Omron E5CN User Manual

Initial Setup Examples

3-1

Initial Setup Examples

Typical example 1
Input type: 0 K thermocouple -200 to 1300°C
Control method: ON/OFF control
Alarm type: 2 upper limit
Alarm value 1: 20°C (deviation)
Set point: 100°C
18
On previous controllers, sensor input type, alarm type and control period were
set by the DIP switches. These hardware settings are now set in parameters
in setup menus. The
menus, and the amount of time that you hold the keys down for determines
which setup menu you move to. This section describes two typical examples.
Setup procedure
Power ON
Initial setting level
Set input
specifications
Set control
specifications
Set alarm type
Operation level
Set alarm values
Start operation
and keys are used to switch between setup
Operation level
Initial setting level
Check input
type.
Check that
control is
ON/OFF control.
Check alarm
type.
Operation level
Press keys
to set point to
"100°C".
Make sure that
control is
running.
Press keys
to set alarm
value to "20°C".
Start operation
Section 3-1
Power ON
25
Process value/
set point
0
Press key for at least
three seconds.
Control stops.
in-t
Input type
0
4
onof
cntl
In ON/OFF
control
onof
stop
In PID control
alt1
Alarm 1 type 2
2
Press key for at
least one second.
25
Process value/
100
set point 100
run
r-5
During run
run During stop stop
al-1
Alarm value 1 20
20