Omron E5CN User Manual page 76

Operation Level
PV
Function
Monitor
See
PV/SP
Function
Monitor
See
m-sp
Multi-SP (set point 0 to 3)
Function
66
The process value is displayed on the No.1 display, and nothing is displayed
(blank) on the No.2 display.
Process Input range lower limit -10%FS to input range upper limit
Value +10%FS
Scaling lower limit -10%FS to scaling upper limit +10%FS
The decimal point position is dependent on the selected sensor.
Related parameters
"Input type" (initial setting level)
"Set point upper limit" "Set point lower limit" (initial setting level)
The process value is displayed on the No.1 display, and the set point is dis-
played on the No.2 display.
Process Input range lower limit -10%FS to input range upper limit
Value +10%FS
Scaling lower limit -10%FS to scaling upper limit +10%FS
Set Point Set point lower limit to set point upper limit
The decimal point position is dependent on the selected sensor.
Refer to the PV parameter.
Multi-SP allows you to set up to four set points (SP0 to 3) in adjustment level.
These can be switched by operating the keys on the front panel or by external
input signals (event input). In the parameter, enter set points 0 to 3.
The "additional PV display" parame-
ter must be set to "ON".
Monitor Range
Monitor Range
The "multi-SP uses" parameter must
be set to "ON".
Section 5-3
Unit
EU
Unit
EU
EU