Initial Setting Level - Omron E5CN User Manual

Initial Setting Level

5-5 Initial Setting Level
This level is for setting up the basic specifications of the E5CN. In this level,
you can set the "input type" parameter for selecting the sensor input to be
connected to the E5CN, limit the setting range of set points or set the alarm
mode.
Power ON
Operation
Adjustment
level
level
key
less than
1 sec.
key 3 seconds min.
key
25
key
1 second
100
min.
Control stops
Initial setting
level
key
less than
1 sec.
To move from the operation level to
the initial setting level, press
for three seconds or more.
• The initial setting level is not dis-
played when "initial/communica-
tions protection" is set to "2".
This initial setting level can be
used when "initial setting/com-
munications protection" is set to
"0" or "1".
• The "scaling upper limit", "scal-
ing lower limit" and "decimal
point" parameters are displayed
when analog input is selected as
the input type.
Initial setting level
No.1 display flashes.
Commu-
nications
setup level
Control in progress
Control stopped
key
Section 5-5
Page
Input type
80
Scaling upper limit
81
Scaling lower limit
81
Decimal point
81
°C/°F selection
82
Set point upper limit
82
Set point lower limit
82
PID / ON/OFF
83
Standard/heating and
cooling
83
ST
84
Control period (OUT1)
84
Control period (OUT2)
84
Direct/reverse operation
85
Alarm 1 type
85
Alarm 2 type
86
Move to advanced
function setting level
79