Adjusting Manually - Roland SP-300 User Manual

Adjusting Manually

Read the adjustment value from the test pattern printed and cut on the media. Enter the read adjustment value with the
operation panel, then align the printing and cutting positions.
1 Load media and install a blade.
Make sure the [SET UP] light is illuminated.
2 Go to "Adjusting Automatically" on the previ-
ous page and carry out steps 2 through 4.
The screen shown in the figure appears.
Press the [ENTER] key.
3
Printing and cutting a test pattern are performed.
From the test pattern, read the value at the lo-
4
cation shown in the figure.
Test pattern
Adjustment-value scale
+2.0
Feed direction
-2.0
5 Press the [ ] key to select [FEED SETTING].
6 Press the [ ] key.
The screen shown in the figure appears.
Press the [ ] and [ ] keys to enter the feed-
7
direction adjustment value read in step 5, then
press the [ENTER] key.
8 Repeat steps 6 through 8 and enter the adjust-
ment value for [SCAN SETTING].
Scan direction
+2.0 -2.0
+1.5 -1.5
+1.0 -1.0
+0.5 -0.5
+0.0 -0.0
Scan
+1.5 +1.0 +0.5 +0.0
Feed
-1.5 -1.0 -0.5 -0.0
4-4 Making Corrections for Printing and Cutting
PRINT - CUT ADJ.
TEST PRINT
Cutting line
PRINT - CUT ADJ.
FEED SETTING
FEED SETTING
4. A wide variety of Operations
Cutting line
-0.5
Read the scale on which the
cutting line goes over as the
adjustment value.
In this figure, the value is "-0.3."
Use the same method to read
the value for the feed direction.
+ 0.0 mm + 0.0 mm
67