Thermostat Screen; Figure 2-3 Thermostat (Default) Screen; Table 2-2 Thermostat Screen Options - Proliphix Professional NT100e/h Configuration Manual

CHAPTER 2: Configuring the Thermostat Using the TDI

Thermostat Screen

Figure 2-3
this screen with a minimal ambient backlight. The backlight intensifies after you click
any button.

Figure 2-3 Thermostat (Default) Screen

Zone
Temperature
The thermostat display reverts back to the default LCD screen after 16 seconds of
keypad inactivity.
Note
Table 2-2

Table 2-2 Thermostat Screen Options

Field
Zone Name (network host
name)
Button Lockout
Alarm Indication
Network Connectivity
Zone Temperature
2-4
Beta Draft Confidential
shows the default Thermostat screen. The thermostat constantly displays
Zone Name
lists the thermostat LCD screen options.
Description
Initially, the Zone Name is set to the last six digits of the network
MAC address (e.g. 00-00-6A).
When visible, indicates that some or all of the thermostat buttons
are disabled from controlling the thermostat.
When visible, indicates that an alarm condition exists within the
thermostat. Alarm conditions include Low and High
Temperature and Filter Change notifications.
When visible, indicates that the thermostat is connected to an
Ethernet network. When blinking, indicates an active Ethernet
network (network activity).
Indicates the current zone temperature in degrees Fahrenheit or
Celsius. If remote sensors are installed, enabled, and configured
to average with the local thermostat sensor, this field indicates the
average temperature of the aggregate sensors.
Professional Series Network Thermostat Configuration Guide, Release 3.0
Alarm Notification
Button Lockout
Heat Setpoint Temperature
Part No. 600-01000-200, Rev. 2
Network
Connectivity
Cool Setpoint
Temperature